Before & After Photos

This below grade garage in Hamilton, OH, leaked heavily during rains. We wrapped the exterior walls with our WaterGuard subfloor drainage system to invite built up water into the system. The drainage installation process included: trenching out the floor around the perimeter, drilling weep holes through the blocks, fitting our system into the trenches, pitching the system with gravel, and concealing the system with a fresh layer of concrete. The weep holes were key in this process, as they helped relieve the foundation of built up hydrostatic pressure. We then installed a SuperSump sump pump with a battery backup system in the corner of the basement to help discharge the water far away from the home. 

The buyer and seller of this home in Independence, KY, decided to split the cost of this waterproofing project. Our Real Estate Inspector, Donny, was able to help guide this transaction and project for a seamless operation. We installed a full interior perimeter waterproofing system for the basement consisting of our WaterGuard subfloor drains and our SuperSump sump pump. The basement was leaking at the coves of the poured foundation, so our WaterGuard subfloor drains will do a great job at intercepting built up water around the coves of the basement. Now that the basement is protected, the new homeowner can transform their basement however which way they please. 

This homeowner in Lewisburg, OH, wanted their sump pump replaced, as it was not performing to the expectations of the homeowner. It's open pit was allowing moisture to seep back into the basement, and it was constantly running. We replaced their inefficient sump pump with our TripleSafe sump pump system. Our TripleSafe comes with a battery backup system, seen to the right of the pump in the after photo. The TripleSafe also has three pumps, two discharge lines, a moisture proof lid, and an alarm system. The TripleSafe will do a much better job at keeping water away from this home, all while being way more energy efficient. 

This home was leaking water through their carpet and drywall, so they gave us a call to waterproof a certain area in their finished basement. After we ripped the carpet out, tore out the drywall three feet high from the ground, installed our sump pump and drainage system, we then installed our EverLast wall paneling system. This system is great because after we cut out your drywall out to install our waterproofing system, we can then replace your drywall with this 100% moisture-proof paneling system. This way we don't leave you with a mess, and you don't have to worry about the wall growing mold in the most vulnerable areas! We also think it looks pretty, pretty, pretty good!

This crack repair project in this Cincinnati, OH, basement helped seal up a leaky spot behind the homeowner's drywall. We did have to cut out the drywall on the initial inspection to locate the spot of the crack, right above where the baseboard was wet. Our crack repair system involves chipping away at the crack, digging a hole in the floor of the basement, filling the crack with the first layer of epoxy, lining the epoxy with a foam strip (and wiring the foam strip into the hole in the floor), covering the foam strip with another layer of flexible epoxy, sealing the system with a white wall panel, and then sealing the hole with a gravel backfill and a concrete layer at the top to reseal the floor back together.