Before & After Photos

The front step had sank 3/4 to 1" on the left side.  If you look closely at the before picture under the threshold and then look at the after you can see a dramatic improvement.  The walkway was also lifted with PolyLevel and sealed with NexusePro.  The large crack in the walkway had a severe trip hazard that we were able to level out.  The entire surface underneath was stabilized and will hold up for a long time.

Customer's RV pad had sank in the middle up to 1".  Defender Concrete Solutions was able to successfully lift and stabilize the entire area using PolyLevel.  We then sealed the joints around the repaired area with Nexus Pro joint and crack sealer.  The customer was very pleased with the results and the time it took us to have the pad in a condition to where he could utilize it again!

A customer's steps had sank on one side and began to pull away from the house.  Defender Concrete Solutions was able to drill a small pilot hole through the entire stoop and then use PolyLevel to lift the entire stoop back into place.  We then used Nexus Pro to seal around the edges to prevent water from getting in and under the steps again.  This job was completed in under two hours.

This customer had a huge void under her concrete that you could actually feel while jumping on it.  The concrete had begun to sink, which created a crack down the middle.  Defender Concrete Solutions used PolyLevel foam to lift the lower portion and stabilize the whole slab to prevent future settling.  We then sealed all the joints with NexusPro, a UV resistant joint sealer that will not crack and remains flexible.  This will prevent moisture from getting under the surface again.  The customer was please with the new look and peace of mind that she will not have to worry about it getting worse and having to replace.

You can see Compression Guard that was added in the picture. Compression Guard is engineered thermo plastic that allows the slabs of your concrete to expand and contract without damaging the concrete. The slab pictured here pushed toward the garage and then retracted and settled. Defender lifted the slabs back into place, sealed the exposed joint and then added the compression guard to protect the slab in the future.