Concrete Leveling & Repair in Fort Worth, TX!
PolyLEVEL™ is a less abrasive and cost-saving alternative to concrete lifting & leveling. The entire concrete lifting process is less destructive and offers numerous benefits over typical slab raising methods. Our Fort Worth contractors are the only professionals trained and to provide the PolyLEVEL™ concrete lifting solution.
The PolyLevel Concrete lifting and slab-raising applications will work for the many variations of sinking and settling concrete, including:
• Concrete driveways and concrete steps
• Interior floor slabs
• Concrete pool decks or pool surrounds
• Sunrooms with concrete floors
• Concrete roadways & parking areas
• Airport runways
• Concrete patios & landings
The Best Alternative to mudjacking and slab jacking
Mudjacking, or pressure grouting, are solutions that require the demolition and replacement of an entire slab of concrete, a procedure that is time consuming and expensive. PolyLevel’s two-part foam expands instantaneously upon injection beneath a settled slab. The injection holes are small and much less abrasive than those required for mud jacking. During the injection process, PolyLEVEL expands many times its original volume, forcing the sunken concrete back to its initial level. It takes only a matter of minutes for the polymer to expand and reach more than 90% of its firmness!
Recent job requests for PolyLevel in Fort Worth, TX:
Project Location: Old Hemphill Rd., Fort Worth, 76134
Comment: Need estimate for drive lift.
Project Location: Racquet Club Drive, Fort Worth, 76120
Comment: Back patio is sinking
Project Location: Wallington Dr, Fort Worth, 76133
Comment: Need 2 sections of front sidewalk raised and a corner of the front porch.
Project Location: Willow Ridge Rd., Fort Worth, 76103
Comment: I have a driveway that has settled about 1.5 " at an joint. I can fell it as I drive.
Project Location: Bentley Ave, Fort Worth, 76137
Comment: Driveway has a crack down the middle. It can be up to an inch difference depending on temperature and moisture. We are in the process of getting quotes right now for the repair. Thank you.
Project Location: Feather Wind Court, Fort Worth, 76135
Comment: I would like an estimate on a pool deck leveling project. There was a leak under the deck that caused significant movement in the deck. Thank you.
Project Location: Crosswind Dr, Fort Worth, 76179
Comment: Back patio and stair landing are sloping and need to be leveled
Project Location: Adobe Dr, Fort Worth, 76123
Comment: My patio concrete cracked and not leveled. Looking to fix it
Project Location: Rosebud Lane, Fort Worth, 76118
Comment: Garage, patio, and driveway all have cracks that are wide and not level.
Project Location: Clairemont Street, Fort Worth, 76103
Comment: After being flat, level and stable for about 6 decades, my front porch has settled toward the house and bowed down in the middle by 2 to 3 inches over the last 10 years.
Project Location: Buffalo Bend Pl., Fort Worth, 76137
Comment: Driveway has sunk about 3 to 4 inches
Project Location: Woodside Hill Ct, Fort Worth, 76179
Comment: I have a concrete patio that is approximately 8' x 12 ' One corner has fell significantly resulting in a gap between the patio and the house foundation. I believe the problem is a result of erosion of the soil under that corner of the patio. Would like to get an estimate to raise the patio back to its original heighth.
Project Location: Diplomacy Road, Fort Worth, 76155
Comment: Engineering studies show we have some voids beneath the slab of our building that need to filled and I would like to obtain a quote.
Project Location: Flint Rock Dr, Fort Worth, 76131
Comment: I have one section of my driveway that has sunk. Additionally, the sidewalk has sunk noticeably where the sidewalk connects to the driveway. I'm thinking a foam solution will fix the problem.
Project Location: Hawthorn Ln, Fort Worth, 76137
Comment: Sunken sidewalk (trip hazard) where s/w meets drive...at 2 separate points, near house and near street. Also driveway beginning to sink where it meet garage apron. Quote please